When closing a device, packets that are in flight
can make it to SendBuffer, which then returns an error.
Those errors add noise but no light;
they do not reflect an actual problem.
Adding the synchronization required to prevent
this from occurring is currently expensive and error-prone.
Instead, quietly drop such packets instead of
returning an error.
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
In each case, the starting waitgroup did nothing but ensure
that the goroutine has launched.
Nothing downstream depends on the order in which goroutines launch,
and if the Go runtime scheduler is so broken that goroutines
don't get launched reasonably promptly, we have much deeper problems.
Given all that, simplify the code.
Passed a race-enabled stress test 25,000 times without failure.
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
Picking two free ports to use for a test is difficult.
The free port we selected might no longer be free when we reach
for it a second time.
On my machine, this failure mode led to failures approximately
once per thousand test runs.
Since failures are rare, and threading through and checking for
all possible errors is complicated, fix this with a big hammer:
Retry if either device fails to come up.
Also, if you accidentally pick the same port twice, delightful confusion ensues.
The handshake failures manifest as crypto errors, which look scary.
Again, fix with retries.
To make these retries easier to implement, use testing.T.Cleanup
instead of defer to close devices. This requires Go 1.14.
Update go.mod accordingly. Go 1.13 is no longer supported anyway.
With these fixes, 'go test -race' ran 100,000 times without failure.
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
This doesn't cause any practical problems as it is,
but vet (rightly) flags this code as copying a mutex.
It is easy to fix, so do so.
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
fix panic: send on closed channel when remove peer
Signed-off-by: Haichao Liu <liuhaichao@bytedance.com>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
Both wireguard-windows and wireguard-android access Bind
directly for these methods now.
Signed-off-by: David Crawshaw <crawshaw@tailscale.com>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
Use the RTMGRP_IPV4_ROUTE const from x/sys/unix instead of using the
corresponding RTNLGRP_IPV4_ROUTE const to create the multicast groups
mask.
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
Peers are currently removed after Device's goroutines are signaled to stop,
but without waiting for them to actually do so, which is racy.
For example, RoutineHandshake may be in Peer.SendKeepalive
when the corresponding peer is removed, which closes its nonce channel.
This causes a send on a closed channel, as observed in tailscale/tailscale#487.
This patch seems to be the correct synchronizing action:
Peer's goroutines are receivers and handle channel closure gracefully,
so Device's goroutines are the ones that should be fully stopped first.
Signed-Off-By: Dmytro Shynkevych <dmytro@tailscale.com>
Go's GC semantics might not always guarantee the safety of this, and the
race detector gets upset too, so instead we wrap this all in atomic
accessors.
Reported-by: David Anderson <danderson@tailscale.com>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
The sticky socket code stays in the device package for now,
as it reaches deeply into the peer list.
This is the first step in an effort to split some code out of
the very busy device package.
Signed-off-by: David Crawshaw <crawshaw@tailscale.com>
Adds a test that will fail consistently on 32-bit platforms if the
struct ever changes again to violate the rules. This is likely not
needed because unaligned access crashes reliably, but this will reliably
fail even if tests accidentally pass due to lucky alignment.
Signed-Off-By: David Anderson <danderson@tailscale.com>
Update the golang.org/x/sys/unix dependency and use the newly introduced
RTMGRP_* consts instead of using the corresponding RTNLGRP_* const to
create a mask.
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
Simplification found by staticcheck:
$ staticcheck ./... | grep S1012
device/cookie.go:90:5: should use time.Since instead of time.Now().Sub (S1012)
device/cookie.go:127:5: should use time.Since instead of time.Now().Sub (S1012)
device/cookie.go:242:5: should use time.Since instead of time.Now().Sub (S1012)
device/noise-protocol.go:304:13: should use time.Since instead of time.Now().Sub (S1012)
device/receive.go:82:46: should use time.Since instead of time.Now().Sub (S1012)
device/send.go:132:5: should use time.Since instead of time.Now().Sub (S1012)
device/send.go:139:5: should use time.Since instead of time.Now().Sub (S1012)
device/send.go:235:59: should use time.Since instead of time.Now().Sub (S1012)
device/send.go:393:9: should use time.Since instead of time.Now().Sub (S1012)
ratelimiter/ratelimiter.go:79:10: should use time.Since instead of time.Now().Sub (S1012)
ratelimiter/ratelimiter.go:87:10: should use time.Since instead of time.Now().Sub (S1012)
Change applied using:
$ find . -type f -name "*.go" -exec sed -i "s/Now().Sub(/Since(/g" {} \;
Signed-off-by: Matt Layher <mdlayher@gmail.com>
