Update release notes and change log for 1.3.4

git-svn-id: https://shorewall.svn.sourceforge.net/svnroot/shorewall/trunk@137 fbd18981-670d-0410-9b5c-8dc0c1a9a2bb

Shorewall/changelog.txt

@@ -1,31 +1,9 @@
-Changes since 1.3.2
+Changes since 1.3.3
 
-1. Correct detection of duplicate entries in the interfaces file.
-2. Clear command now flushes all chains.
-3. Clear command enables forwarding.
-4. Corrected indentation in check_config()
-5. Reorganized the code for processing the rules file.
-6. Reorganized tunnel creation.
-7. Automatically generate 'multi' for wildcard interfaces.
-8. Renamed the mangle table's rfc1918 chain to man1918.
-9. The TARGET column in the rfc1918 file is now validated.
-10. Corrected ICMP protocol number in a case statement.
-11. Interfaces named in the hosts file are now validated against the 
-    interfaces file.
-12. Changed the usage of the nat table to correct problems with
-    NAT_BEFORE_RULES=No.
+1. DETECT_IPADDRS Parameter Added.
 
+2. Renamed DETECT_IPADDRS to DETECT_DNAT_IPADDRS
 
+3. Correct policy file zone validateion during [re]start.
 
-
-
-
-
-
-
-
-
-
-
-
- 
+4. Add 'routestopped' file. 

Shorewall/fallback.sh

@@ -28,7 +28,7 @@
 #       shown below. Simply run this script to revert to your prior version of 
 #       Shoreline Firewall.
 
-VERSION=1.3.3
+VERSION=1.3.4
 
 usage() # $1 = exit status
 {

Shorewall/install.sh

@@ -54,7 +54,7 @@
 #        /etc/rc.d/rc.local file is modified to start the firewall.
 #
 
-VERSION=1.3.3
+VERSION=1.3.4
 
 usage() # $1 = exit status
 {

Shorewall/releasenotes.txt

@@ -2,28 +2,22 @@ This is a minor release of Shorewall.
 
 In this release:
 
-1. Entries in /etc/shorewall/interface that use the wildcard character
-   ("+") now have the "multi" option assumed.
-
-2. The 'rfc1918' chain in the mangle table has been renamed 'man1918'
-   to make log messages generated from that chain distinguishable from
-   those generated by the 'rfc1918' chain in the filter table.
-
-3. Interface names appearing in the hosts file are now validated
-   against the interfaces file.
-
-4. The TARGET column in the rfc1918 file is now checked for
-   correctness.
-
-5. The 'hits' command has been enhanced.
-
-6. The structure of chains in the nat table has been changed to reduce
-   the number of rules that packets must traverse and to correct
-   problems with NAT_BEFORE_RULES=No. 
-
-
-
+1. A new /etc/shorewall/routestopped file has been added. This file is 
+   intended to eventually replace the routestopped option in the 
+   /etc/shorewall/interface and /etc/ shorewall/hosts files. This new 
+   file makes remote firewall administration easier by allowing any IP 
+   or subnet to be enabled while Shorewall is stopped.
 
+2. An /etc/shorewall/stopped extension script has been added. This 
+   script is invoked after Shorewall has stopped.
 
+3. A DETECT_DNAT_ADDRS option has been added to 
+   /etc/shoreall/shorewall.conf. When this option is selected, DNAT 
+   rules only apply when the destination address is the external
+   interface's primary IP address.
 
+4. The QuickStart Guide has been broken into three guides and has been
+   almost entirely rewritten.
 
+5. The Samples have been updated to reflect the new capabilities in
+   this release.

Shorewall/shorewall.spec

@@ -1,5 +1,5 @@
 %define name shorewall
-%define version 1.3.3
+%define version 1.3.4
 %define release 1
 %define prefix /usr
 
@@ -80,6 +80,8 @@ if [ $1 = 0 ]; then if [ -x /sbin/insserv ]; then /sbin/insserv -r /etc/init.d/s
 %doc COPYING INSTALL changelog.txt releasenotes.txt tunnel
 
 %changelog
+* Sat Jul 13 2002 Tom Eastep <tom@shorewall.net>
+- Changed version to 1.3.4
 * Web Jul 10 2002 Tom Eastep <tom@shorewall.net>
 - Added 'routestopped' configuration file.
 * Fri Jul 05 2002 Tom Eastep <tom@shorewall.net>

Shorewall/uninstall.sh

@@ -26,7 +26,7 @@
 #       You may only use this script to uninstall the version
 #       shown below. Simply run this script to remove Seattle Firewall
 
-VERSION=1.3.3
+VERSION=1.3.4
 
 usage() # $1 = exit status
 {