Tom Eastep 2005-09-30 2002-2005 Thomas M. Eastep Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, with no Front-Cover, and with no Back-Cover Texts. A copy of the license is included in the section entitled GNU Free Documentation License. This article applies to Shorewall 3.0 and later. If you are running a version of Shorewall earlier than Shorewall 3.0.0 then please see the documentation for that release. If you wish to run Samba on your firewall and access shares between the firewall and local hosts, you need the following rules: #ACTION SOURCE DEST PROTO DEST PORT(S) SOURCE # PORT(S) SMB/ACCEPT $FW loc SMB/ACCEPT loc $FW To pass traffic SMB/Samba traffic between zones Z1 and Z2: #ACTION SOURCE DEST PROTO DEST PORT(S) SOURCE # PORT(S) SMB/ACCEPT Z1 Z2 SMB/ACCEPT Z2 Z1 To make network browsing (Network Neighborhood) work properly between Z1 and Z2 requires a Windows Domain Controller and/or a WINS server. I have run Samba on my firewall to handle browsing between two zones connected to my firewall. When debugging Samba/SMB problems, I recommend that you do the following: Copy action.Drop and action.Reject from /usr/share/shorewall to /etc/shorewall. Edit the copies and remove the SMB/DROP and SMB/REJECT lines. shorewall restart The above steps will cause SMB traffic that is dropped or rejected by policy to be logged rather than handled silently. If you are using Windows XP to test your setup,make you sure you have a properly configured client firewall . You can just remove the copies and shorewall restart when you are finished debugging.