Tom Eastep 2003-11-22 2001 2002 2003 Thomas M. Eastep Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, with no Front-Cover, and with no Back-Cover Texts. A copy of the license is included in the section entitled "GNU Free Documentation License".

If all you want to do is forward ports to servers behind your firewall, you do NOT want to use one-to-one NAT. Port forwarding can be accomplished with simple entries in the rules file. One-to-one NAT is a way to make systems behind a firewall and configured with private IP addresses (those reserved for private use in RFC 1918) appear to have public IP addresses. Before you try to use this technique, I strongly recommend that you read the Shorewall Setup Guide. The following figure represents a one-to-one NAT environment. One-to-one NAT can be used to make the systems with the 10.1.1.* addresses appear to be on the upper (130.252.100.*) subnet. If we assume that the interface to the upper subnet is eth0, then the following /etc/shorewall/NAT file would make the lower left-hand system appear to have IP address 130.252.100.18 and the right-hand one to have IP address 130.252.100.19. EXTERNAL INTERFACE INTERNAL ALL INTERFACES LOCAL 130.252.100.18 eth0 10.1.1.2 yes yes 130.252.100.19 eth0 10.1.1.3 yes yes Be sure that the internal system(s) (10.1.1.2 and 10.1.1.3 in the above example) is (are) not included in any specification in /etc/shorewall/masq or /etc/shorewall/proxyarp. The "ALL INTERFACES" column is used to specify whether access to the external IP from all firewall interfaces should undergo NAT (Yes or yes) or if only access from the interface in the INTERFACE column should undergo NAT. If you leave this column empty, "Yes" is assumed. The ALL INTERFACES column was added in version 1.1.6. Specifying "Yes" in this column will not allow systems on the lower LAN to access each other using their public IP addresses. For example, the lower left-hand system (10.1.1.2) cannot connect to 130.252.100.19 and expect to be connected to the lower right-hand system. See FAQ 2a. Shorewall will automatically add the external address to the specified interface unless you specify ADD_IP_ALIASES="no" (or "No") in /etc/shorewall/shorewall.conf; If you do not set ADD_IP_ALIASES or if you set it to "Yes" or "yes" then you must NOT configure your own alias(es). Shorewall versions earlier than 1.4.6 can only add external addresses to an interface that is configured with a single subnetwork -- if your external interface has addresses in more than one subnetwork, Shorewall 1.4.5 and earlier can only add addresses to the first one. The contents of the "LOCAL" column determine whether packets originating on the firewall itself and destined for the EXTERNAL address are redirected to the internal ADDRESS. If this column contains "yes" or "Yes" (and the ALL INTERFACES COLUMN also contains "Yes" or "yes") then such packets are redirected; otherwise, such packets are not redirected. The LOCAL column was added in version 1.1.8.