shorewall-interfaces 5 interfaces Shorewall interfaces file /etc/shorewall/interfaces Description The interfaces file serves to define the firewall's network interfaces to Shorewall. The columns in the file are as follows. ZONE — zone-name Zone for this interface. Must match the name of a zone declared in /etc/shorewall/zones. You may not list the firewall zone in this column. If the interface serves multiple zones that will be defined in the shorewall-hosts(5) file, you should place "-" in this column. If there are multiple interfaces to the same zone, you must list them in separate entries. Example:
#ZONE INTERFACE BROADCAST loc eth1 - loc eth2 -
INTERFACE — interface Name of interface. Each interface may be listed only once in this file. You may NOT specify the name of a "virtual" interface (e.g., eth0:0) here; see http://www.shorewall.net/FAQ.htm#faq18 You may use wildcards here by specifying a prefix followed by the plus sign ("+"). For example, if you want to make an entry that applies to all PPP interfaces, use 'ppp+'; that would match ppp1, ppp2, … There is no need to define the loopback interface (lo) in this file. BROADCAST (Optional) — {-|detect|address[,address]...} The broadcast address(es) for the network(s) to which the interface belongs. For P-T-P interfaces, this column is left blank.If the interface has multiple addresses on multiple subnets then list the broadcast addresses as a comma-separated list. If you use the special value detect, Shorewall will detect the broadcast address(es) for you. If you select this option, the interface must be up before the firewall is started. If you don't want to give a value for this column but you want to enter a value in the OPTIONS column, enter - in this column. OPTIONS (Optional) — [option[,option]...] A comma-separated list of options from the following list. The order in which you list the options is not significant but the list should have no embedded white space. dhcp Specify this option when any of the following are true: the interface gets its IP address via DHCP the interface is used by a DHCP server running on the firewall you have a static IP but are on a LAN segment with lots of DHCP clients. the interface is a bridge with a DHCP server on one port and DHCP clients on another port. norfc1918 This interface should not receive any packets whose source is in one of the ranges reserved by RFC 1918 (i.e., private or "non-routable" addresses). If packet mangling or connection-tracking match is enabled in your kernel, packets whose destination addresses are reserved by RFC 1918 are also rejected. routefilter Turn on kernel route filtering for this interface (anti-spoofing measure). This option does not work with a wild-card interface name (e.g., eth0.+) in the INTERFACE column. This option can also be enabled globally in the shorewall.conf(5) file. logmartians Turn on kernel martian logging (logging of packets with impossible source addresses. It is strongly suggested that if you set routefilter on an interface that you also set logmartians. Even if you do not specify the option, it is a good idea to specify because your distribution may be enabling route filtering without you knowing it. To find out if route filtering is set on a given interface, check the contents of /proc/sys/net/ipv4/conf/interface/rp_filter — a non-zero value indicates that route filtering is enabled. Example: teastep@lists:~$ cat /proc/sys/net/ipv4/conf/eth0/rp_filter 1 teastep@lists:~$ This option does not work with a wild-card interface name (e.g., eth0.+) in the INTERFACE column. This option may also be enabled globally in the shorewall.conf(5) file. blacklist Check packets arriving on this interface against the shorewall-blacklist(5) file. maclist Connection requests from this interface are compared against the contents of shorewall-maclist(5). If this option is specified, the interface must be an ethernet NIC and must be up before Shorewall is started. tcpflags Packets arriving on this interface are checked for certain illegal combinations of TCP flags. Packets found to have such a combination of flags are handled according to the setting of TCP_FLAGS_DISPOSITION after having been logged according to the setting of TCP_FLAGS_LOG_LEVEL. proxyarp Sets /proc/sys/net/ipv4/conf/interface/proxy_arp. Do NOT use this option if you are employing Proxy ARP through entries in shorewall-proxyarp(5). This option is intended solely for use with Proxy ARP sub-networking as described at: http://tldp.org/HOWTO/Proxy-ARP-Subnet/index.html This option does not work with a wild-card interface name (e.g., eth0.+) in the INTERFACE column. routeback If specified, indicates that Shorewall should include rules that allow filtering traffic arriving on this interface back out that same interface. This option is also required when you have used a wildcard in the INTERFACE column if you want to allow traffic between the interfaces that match the wildcard. arp_filter If specified, this interface will only respond to ARP who-has requests for IP addresses configured on the interface. If not specified, the interface can respond to ARP who-has requests for IP addresses on any of the firewall's interface. The interface must be up when Shorewall is started. This option does not work with a wild-card interface name (e.g., eth0.+) in the INTERFACE column. arp_ignore[=number] If specified, this interface will respond to arp requests based on the value of number (defaults to 1). 1 - reply only if the target IP address is local address configured on the incoming interface 2 - reply only if the target IP address is local address configured on the incoming interface and the sender's IP address is part from same subnet on this interface 3 - do not reply for local addresses configured with scope host, only resolutions for global and link 4-7 - reserved 8 - do not reply for all local addresses This option does not work with a wild-card interface name (e.g., eth0.+) in the INTERFACE column. Do not specify arp_ignore for any interface involved in Proxy ARP. nosmurfs Filter packets for smurfs (packets with a broadcast address as the source). Smurfs will be optionally logged based on the setting of SMURF_LOG_LEVEL in shorewall.conf(5). After logging, the packets are dropped. detectnets Automatically tailors the zone named in the ZONE column to include only those hosts routed through the interface. Do not set the detectnets option on your internet interface. sourceroute If this option is not specified for an interface, then source-routed packets will not be accepted from that interface (sets /proc/sys/net/ipv4/conf/interface/accept_source_route to 1). Only set this option if you know what you are doing. This might represent a security risk and is not usually needed. This option does not work with a wild-card interface name (e.g., eth0.+) in the INTERFACE column. upnp Incoming requests from this interface may be remapped via UPNP (upnpd). See http://www.shorewall.net/UPnP.html. Example Example 1: Suppose you have eth0 connected to a DSL modem and eth1 connected to your local network and that your local subnet is 192.168.1.0/24. The interface gets it's IP address via DHCP from subnet 206.191.149.192/27. You have a DMZ with subnet 192.168.2.0/24 using eth2. Your entries for this setup would look like: #ZONE INTERFACE BROADCAST OPTIONS net eth0 206.191.149.223 dhcp loc eth1 192.168.1.255 dmz eth2 192.168.2.255 Example 2: The same configuration without specifying broadcast addresses is: #ZONE INTERFACE BROADCAST OPTIONS net eth0 detect dhcp loc eth1 detect dmz eth2 detect Example 3: You have a simple dial-in system with no ethernet connections. #ZONE INTERFACE BROADCAST OPTIONS net ppp0 - FILES /etc/shorewall/interfaces See ALSO http://www.shorewall.net/Documentation.htm#Interfaces shorewall(8), shorewall-accounting(5), shorewall-actions(5), shorewall-blacklist(5), shorewall-hosts(5), shorewall-ipsec(5), shorewall-maclist(5), shorewall-masq(5), shorewall-nat(5), shorewall-netmap(5), shorewall-params(5), shorewall-policy(5), shorewall-providers(5), shorewall-proxyarp(5), shorewall-route_routes(5), shorewall-routestopped(5), shorewall-rules(5), shorewall.conf(5), shorewall-tcclasses(5), shorewall-tcdevices(5), shorewall-tcrules(5), shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)