#	
# 	Shorewall 2.0  -- Sample Interface File For One Interface
#
# 	/etc/shorewall/interfaces
#
#	You must add an entry in this file for each network interface on your
#	firewall system.
#
# Columns are:
#
#	ZONE		Zone for this interface. Must match the short name
#			of a zone defined in /etc/shorewall/zones.
#
#			If the interface serves multiple zones that will be
#			defined in the /etc/shorewall/hosts file, you should
#			place "-" in this column.
#	
#	INTERFACE	Name of interface. Each interface may be listed only
#			once in this file. You may NOT specify the name of
#			an alias (e.g., eth0:0) here; see
#			http://www.shorewall.net/FAQ.htm#faq18
#			
#			You may specify wildcards here. For example, if you 
#			want to make a entry that applies to all PPP
#			interfaces, use 'ppp+'
#
#			There is no need to define the loopback interface (lo)
#			in this file.
#
#	BROADCAST	The broadcast address for the subnetwork to which the
#			interface belongs. For P-T-P interfaces, this
#			column is left blank.If the interface has multiple
#			addresses on multiple subnets then list the broadcast
#			addresses as a comma-separated list.
#					    
#			If you use the special value "detect", the firewall
#			will detect the broadcast address for you. If you
#			select this option, the interface must be up before
#			the firewall is started, you must have iproute
#			installed and the interface must only be associated
#			with a single subnet.
#
#			If you don't want to give a value for this column but
#			you want to enter a value in the OPTIONS column, enter
#			"-" in this column.
#
#	OPTIONS		A comma-separated list of options including the
#			following:
#
#			dhcp
#					Interface is managed by DHCP or used by
#					a DHCP server running on the firewall or
#					you have a static IP but are on a LAN
#					segment with lots of Laptop DHCP clients.
#			norfc1918
#					This interface should not receive
#					any packets whose source is in one
#					of the ranges reserved by RFC 1918
#					(i.e., private or "non-routable"
#					addresses. If packet mangling is
#					enabled in shorewall.conf, packets
#					whose destination addresses are
#					reserved by RFC 1918 are also rejected.
#			routefilter
#					Turn on kernel route filtering for this
#					interface (anti-spoofing measure). This
#					option can also be enabled globally in
#					the /etc/shorewall/shorewall.conf file.
#			blacklist
#					Check packets arriving on this interface
#					against the /etc/shorewall/blacklist
#					file.
#			maclist
#					Connection requests from this interface
#					are compared against the contents of
#					/etc/shorewall/maclist. If this option
#					is specified, the interface must be
#					an ethernet NIC and must be up before
#					Shorewall is started.
#			tcpflags
#					Packets arriving on this interface are
#					checked for certain illegal combinations
#					of TCP flags. Packets found to have
#					such a combination of flags are handled
#					according to the setting of
#					TCP_FLAGS_DISPOSITION after having been
#					logged according to the setting of
#					TCP_FLAGS_LOG_LEVEL.
#			proxyarp
#					Sets /proc/sys/net/ipv4/conf/<interface>/proxy_arp.
#					Do NOT use this option if you are
#					employing Proxy ARP through entries in
#					/etc/shorewall/proxyarp. This option is
#					intended soley for use with Proxy ARP
#					sub-networking as described at:
#					http://www.tldp.org/HOWTO/mini/Proxy-ARP-Subnet
#			newnotsyn
#					TCP packets that don't have the SYN flag set and 
#					which are not part of an established connection
#					will be accepted from this interface, even if
#					NEWNOTSYN=No has been specified in 
#					/etc/shorewall/shorewall.conf.
#
#					This option has no effect if NEWNOTSYN=Yes
#			routeback    
#					If specified, indicates that Shorewall
#					should include rules that allow filtering
#					traffic arriving on this interface back
#					out that same interface.
#			arp_filter	
#					If specified, this interface will only respond
#					to ARP who-has requests for IP addresses 
#					configured on the interface. If not specified,
#					the interface can respond to ARP who-has requests
#					for IP addresses on any of the firewall's interface.
#					The interface must be up when shorewall is started.
#			nosmurfs
#					Filter packers for smurfs (Packets with a broadcast
#					address as the source).
#			detectnets
#					Automatically taylors the zone named in the ZONE
#					column to include only those hosts routed through
#					the interface.
#
#	WARNING: DO NOT SET THE detectnets OPTION ON YOUR INTERNET INTERFACE!
#
#			The order in which you list the options is not
#			significant but the list should have no embedded white
#			space.
#
#	Example 1:
#			Suppose you have eth0 connected to a DSL modem
#			that gets it's IP address via DHCP from subnet
#			206.191.149.192/27.
#
#			Your entries for this setup would look like:
#
#			#ZONE	INTERFACE	BROADCAST	OPTIONS
#			net	eth0		206.191.149.223	dhcp
#
#	Example 2:
#			The same configuration without specifying broadcast
#			addresses is:
#
#			#ZONE	INTERFACE	BROADCAST	OPTIONS
#			net	eth0		detect		dhcp
#
#	Example 3:
#			You have a simple dial-in system with no ethernet
#			connections.
#			#ZONE	INTERFACE	BROADCAST	OPTIONS
#			net	ppp0		-
##############################################################################
#ZONE	INTERFACE	BROADCAST	OPTIONS
net	eth0		detect		norfc1918,routefilter,dhcp,tcpflags
#LAST LINE -- ADD YOUR ENTRIES BEFORE THIS ONE -- DO NOT REMOVE