shorewall_code/Shorewall2/routes
2005-05-16 18:36:01 +00:00

92 lines
3.2 KiB
Plaintext
Executable File

#
# Shorewall version 2.4 - Routing Rules
#
# /etc/shorewall/routes
#
# Entries in this file cause packets to be routed in non-standard
# ways.
#
# I M P O R T A N T ! ! ! !
#
# In order to use entries in this file, your kernel and iptables must
# have ROUTE target support (see the output of "shorewall show
# capabilities").
#
# To omit any column, enter "-" in that column.
#
# Columns are:
#
#
# SOURCE Source of the packet. May be any of the following:
#
# - A host or network address
# - A network interface name.
# - The name of an ipset prefaced with "+"
# - $FW (for packets originating on the firewall)
# - A MAC address in Shorewall format
# - A range of IP addresses (assuming that your
# kernel and iptables support range match)
# - A network interface name followed by ":"
# and an address or address range.
#
# DEST Destination of the packet. May be any of the
# following:
#
# - A host or network address
# - A network interface name (determined from
# routing table(s))
# - The name of an ipset prefaced with "+"
# - A network interface name followed by ":"
# and an address or address range.
#
# PROTO Protocol - Must be "tcp", "udp", "icmp", "ipp2p",
# a number, or "all". "ipp2p" requires ipp2p match
# support in your kernel and iptables.
#
# PORT(S) Destination Ports. A comma-separated list of Port
# names (from /etc/services), port numbers or port
# ranges; if the protocol is "icmp", this column is
# interpreted as the destination icmp-type(s).
#
# Port ranges are allowed in a list only if your
# kernel and iptables support Extended Multi-port
# match (see the output of "shorewall show capabilities").
#
# If the protocol is ipp2p, this column is interpreted
# as an ipp2p option without the leading "--" (example "bit"
# for bit-torrent). If no PORT is given, "ipp2p" is
# assumed.
#
# SOURCE PORT(S) Source port(s). If omitted, any source port is acceptable.
# Specified as a comma-separated list of port names, port
# numbers or port ranges.
#
# Port ranges are allowed in a list only if your
# kernel and iptables support Extended Multi-port
# match (see the output of "shorewall show capabilities").
#
# TEST Defines a test on the existing packet or connection mark.
# The rule will match only if the test returns true. Tests
# have the format [!]<value>[/<mask>][:C]
#
# Where:
#
# ! Inverts the test (not equal)
# <value> Value of the packet or connection mark.
# <mask> A mask to be applied to the mark before
# testing
# :C Designates a connection mark. If omitted,
# the packet mark's value is tested.
#
# INTERFACE The interface that the packet is to be routed out of.
# If you specify "-" here, then you must enter the IP address
# of a gateway in the GATEWAY column.
#
# GATEWAY The gateway that the packet is to be forewarded through.
#
# See http://shorewall.net/Shorewall_and_Routing.html for additional information.
#######################################################################################
#SOURCE DEST PROTO PORT(S) SOURCE TEST INTERFACE GATEWAY
# PORT(S)
#LAST LINE -- ADD YOUR ENTRIES BEFORE THIS ONE -- DO NOT REMOVE