shorewall_code/Shorewall/changelog.txt

Changes in Shorewall 4.4.9

1)  Auto-detection of bridges.

2)  Correct handling of a logical interface name in the EXTERNAL column
    of proxyarp.

Changes in Shorewall 4.4.8

1)  Correct handling of RATE LIMIT on NAT rules.

2)  Don't create a logging chain for rules with '-j RETURN'.

3)  Avoid duplicate SFQ class numbers.

4)  Fix low per-IP rate limits.

5)  Fix Debian init script exit status

6)  Fix NFQUEUE(queue-num) in policy

7)  Implement -s option in install.sh

8)  Add HKP Macro

9)  Fix multiple policy matches with OPTIMIZE 4 and not KLUDGEFREE

10) Eliminate up-cased variable names that aren't documented options.

11) Don't show 'OLD' capabilities if they are not available.

12) Attempt to flag use of '-' as a port-range separator.

13) Add undocumented OPTIMIZE=-1 setting.

14) Replace OPTIMIZE=-1 with undocumented optimize 4096 which DISABLES
    default optimizations.

15) Add support for UDPLITE

16) Distinguish between 'Started' and 'Restored' in ${VARDIR}/state

17) Issue warnings when 'blacklist' but no blacklist file entries.

18) Don't optimize 'blacklst'.

Changes in Shorewall 4.4.7

1)  Backport optimization changes from 4.5.

2)  Backport two new options from 4.5.

3)  Backport TPROXY from 4.5

4)  Add TC_PRIOMAP to shorewall*.conf

5)  Implement LOAD_HELPERS_ONLY

6)  Avoid excessive module loading with LOAD_HELPERS_ONLY=Yes

7)  Fix case where MARK target is unavailable.

8)  Change default to ADD_IP_ALIASES=No

9)  Correct defects in generate_matrix().

10) Fix and optimize 'nosmurfs'.

11) Use 'OLD_HL_MATCH' to suppress use of 'flow' in Simple TC.

Changes in Shorewall 4.4.6

1)  Fix for rp_filter and kernel 2.6.31.

2)  Add a hack to work around a bug in Lenny + xtables-addons

3)  Re-enable SAVE_IPSETS

4)  Allow both <...> and [...] for IPv6 Addresses.

5)  Port mark geometry change from 4.5.

6)  Add Macro patch from Tuomo Soini

7)  Add 'show macro' command.

8)  Add -r option to check.

9)  Port simplified TC from 4.5.

Changes in Shorewall 4.4.5

1)  Fix 15-port limit removal change.

2)  Fix handling of interfaces with the 'bridge' option.

3)  Generate error for port number 0

4)  Allow zone::serverport in rules DEST column.

5)  Fix 'show policies' in Shorewall6.

6)  Auto-load tc modules.

7)  Allow LOGFILE=/dev/null

8)  Fix shorewall6-lite/shorecap

9) Fix MODULE_SUFFIX.

10) Fix ENHANCED_REJECT detection for IPv4.

11) Fix DONT_LOAD vs 'reload -c'

12) Fix handling of SOURCE and DEST vs macros.

13) Remove silly logic in expand_rule().

14) Add current and limit to Conntrack Table Heading.

Changes in Shorewall 4.4.4

1)  Change STARTUP_LOG and LOG_VERBOSITY in default shorewall6.conf.

2)  Fix access to uninitialized variable.

3)  Add logrotate scripts.

4)  Allow long port lists in /etc/shorewall/routestopped.

5)  Implement 'physical' interface option.

6)  Implement ZONE2ZONE option.

7)  Suppress duplicate COMMENT warnings.

8)  Implement 'show policies' command.

9)  Fix route_rule suppression for down provider.

10) Suppress redundant tests for provider availability in route rules
    processing.

11) Implement the '-l' option to the 'show' command.

12) Fix class number assignment when WIDE_TC_MARKS=Yes

13) Allow wide marks in tcclasses when WIDE_TC_MARKS=Yes

Changes in Shorewall 4.4.3

1)  Move Debian INITLOG initialization to /etc/default/shorewall

2)  Fix 'routeback' in /etc/shorewall/routestopped.

3)  Rename 'object' to 'script' in compiler and config modules.

4)  Correct RETAIN_ALIASES=No.

5)  Fix detection of IP config.

6)  Fix nested zones.

7)  Move all function declarations from prog.footer to prog.header

8)  Remove superfluous variables from generated script

9)  Make 'track' the default.

10)  Add TRACK_PROVIDERS option.

11)  Fix IPv6 address parsing bug.

12)  Add hack to work around iproute IPv6 bug in route handling

13)  Correct messages issued when an optional provider is not usable.

14)  Fix optional interfaces.

15)  Add 'limit' option to tcclasses.

Changes in Shorewall 4.4.2

1)  BUGFIX: Correct detection of Persistent SNAT support

2)  BUGFIX: Fix chain table initialization

3)  BUGFIX: Validate routestopped file on 'check'

4)  Let the Actions module add the builtin actions to
    %Shorewall::Chains::targets. Much better modularization that way.

5)  Some changes to make Lenny->Squeeze less painful.

6)  Allow comments at the end of continued lines.

7)  Call process_routestopped() during 'check' rather than
    'compile_stop_firewall()'.

8)  Don't look for an extension script for built-in actions.

9)  Apply Jesse Shrieve's patch for SNAT range.

10) Add -<family> to 'ip route del default' command.

11) Add three new columns to macro body.

12) Change 'wait4ifup' so that it requires no PATH

13) Allow extension scripts for accounting chains.

14) Allow per-ip LIMIT to work on ancient iptables releases.

15) Add 'MARK' column to action body.

Changes in Shorewall 4.4.1

1)  Deleted extra 'use ...IPAddrs.pm' from Nat.pm.

2)  Deleted superfluous export from Chains.pm.

3)  Added support for --persistent.

4)  Don't do module initialization in an INIT block.

5)  Minor performance improvements.

6)  Add 'clean' target to Makefile.

7)  Redefine 'full' for sub-classes.

8)  Fix log level in rules at the end of INPUT and OUTPUT chains.

9)  Fix nested ipsec zones.

10) Change one-interface sample to IP_FORWARDING=Off.

11) Allow multicast to non-dynamic zones defined with nets=.

12) Allow zones with nets= to be extended by /etc/shorewall/hosts
    entries.

13) Don't allow nets= in a multi-zone interface definition.

14) Fix rule generated by MULTICAST=Yes

15) Fix silly hole in zones file parsing.

16) Tighen up zone membership checking.

17) Combine portlist-spitting routines into a single function.

Changes in Shorewall 4.4.0

1)  Fix 'compile ... -' so that it no longer requires '-v-1'

2)  Fix rule generation for logging nat rules with no exclusion.

3)  Fix log record formatting.

4)  Restore ipset binding

5)  Fix 'upnpclient' with required interfaces.

6)  Fix provider number in masq file.

Changes in Shorewall 4.4.0-RC2

1)  Fix capabilities file with Shorewall6.

2)  Allow Shorewall6 to recognize TC, IP and IPSET

3)  Make 'any' a reserved zone name.

4)  Correct handling of an ipsec zone nested in a non-ipsec zone.

Changes in Shorewall 4.4.0-RC1

1)  Delete duplicate Git macro.

2)  Fix routing when no providers.

3)  Add 'any' as a SOURCE/DEST in rules.

4)  Fix NONAT on child zone.

5)  Fix rpm -U from earlier versions

6)  Generate error on 'status' by non-root.

7)  Get rid of prog.functions and prog.functions6

Changes in Shorewall 4.4.0-Beta4

1)  Add more macros.

2)  Correct broadcast address detection

3) Fix 'show dynamic'

4) Fix BGP and OSFP macros.

5) Change DISABLE_IPV6 default and use 'correct' ip6tables.

Changes in Shorewall 4.4.0-Beta3

1)  Add new macros.

2)  Work around mis-configured interfaces.

3)  Fix 'show dynamic'.

4)  Check for xt_LOG.

5)  Fix 'findgw'

Changes in Shorewall 4.4.0-Beta2

1)  The 'find_first_interface_address()' and
    'find_first_interface_address_if_any()' functions have been restored to
    lib.base.

2)  Integerize r2q before inserting it into 'tc qdisc add root'
    command.

3)  Remove '-h' from the help text for install.sh in Shorewall and
    Shorewall6.

4)  Delete the 'continue' file from the Shorewall package.

5)  Add 'upnpclient' interface option.

6)  Fix handling of optional interfaces.

7)  Add 'iptrace' and 'noiptrace' command.

8)  Add 'USER/GROUP' column to masq file.

9)  Added lib.private.

Changes in Shorewall 4.4.0-Beta1

1)  Correct typo in Shorewall6 two-interface sample shorewall.conf.

2)  Fix TOS mnemonic handling in /etc/shorewall/tcfilters.

Changes in Shorewall 4.3.12

1) Eliminate 'large quantum' warnings.

2) Add HFSC support.

3) Delete support for ipset binding. Jozsef has removed the capability
   from ipset.

4) Add TOS and LENGTH columns to tcfilters file.

5) Fix 'reset' command.

6) Fix 'findgw'.

7) Remove 'norfc1918' support.

Changes in Shorewall 4.3.11

1) Reduce the number of arguments passed in may cases.

2) Fix SCTP source port handling in tcfilters.

3) Add 'findgw' user exit.

4) Add macro.Trcrt

Changes in Shorewall 4.3.10

1) Fix handling of shared optional providers.

2) Add WIDE_TC_MARKS option.

3) Allow compile to STDOUT.

4) Fix handling of class IDs.

5) Deprecate use of an interface in the SOURCE column of
   /etc/shorewall/masq.

6) Fix handling of 'all' in the SOURCE of DNAT- rules.

7) Fix compile for export.

8) Optimize IPMARK.

9) Implement nested HTB classes.

10) Fix 'iprange' command.

11) Make traffic shaping work better with IPv6.

12) Externalize 'flow'.

13) Fix 'start' with AUTOMAKE=Yes

Changes in Shorewall 4.3.9

1) Logging rules now create separate chain.

2) Fix netmask genereation in tcfilters.

3) Allow Shorewall6 with kernel 2.6.24

4) Avoid 'Invalid BROADCAST address' errors.

5) Allow Shorewall6 on kernel 4.2.24:Shorewall/changelog.txt

6) Add IP, TC and IPSET options in shorewall.conf and shorewall6.conf.

7) Add IPMARK support

Changes in Shorewall 4.3.8

1) Apply Tuomo Soini's patch for USE_DEFAULT_RT.

2) Use 'startup_error' for those errors caught early.

3) Fix swping

4) Detect gateway via dhclient leases file.

5) Suppress leading whitespace on certain continuation lines.

6) Use iptables[6]-restore to stop the firewall.

7) Add AUTOMAKE option

8) Remove SAME support.

9) Allow 'compile' without a pathname.

10) Fix LOG_MARTIANS=Yes.

11) Adapt I. Buijs's hashlimit patch.

Changes in Shorewall 4.3.7

1)  Fix forward treatment of interface options.

2)  Replace $VARDIR/.restore with $VARDIR/firewall

3)  Fix DNAT- parsing of DEST column.

4)  Implement dynamic zones

5)  Allow 'HOST' options on bridge ports.

6)  Deprecate old macro parameter syntax.

Changes in Shorewall 4.3.6

1)  Add SAME tcrules target.

2)  Make 'dump' display the raw table. Fix shorewall6 dump anomalies.

3)  Fix split_list1()

4)  Fix Shorewall6 file location bugs.

Changes in Shorewall 4.3.5

1)  Remove support for shorewall-shell.

2)  Combine shorewall-common and shorewall-perl to produce shorewall.

3)  Add nets= OPTION in interfaces file.