# This is a configuration file for Zabbix web_service
# To get more information about Zabbix, visit https://www.zabbix.com

############ GENERAL PARAMETERS #################

### Option: LogType
#	Specifies where log messages are written to:
#		system  - syslog
#		file    - file specified with LogFile parameter
#		console - standard output
#
# Mandatory: no
# Default:
# LogType=file

LogType=console

### Option: DebugLevel
#	Specifies debug level:
#	0 - basic information about starting and stopping of Zabbix processes
#	1 - critical information
#	2 - error information
#	3 - warnings
#	4 - for debugging (produces lots of information)
#	5 - extended debugging (produces even more information)
#
# Mandatory: no
# Range: 0-5
# Default:
# DebugLevel=3

DebugLevel=${ZBX_DEBUGLEVEL}

### Option: AllowedIP
#	List of comma delimited IP addresses, optionally in CIDR notation, or DNS names of Zabbix servers and Zabbix proxies.
#	Incoming connections will be accepted only from the hosts listed here.
#	If IPv6 support is enabled then '127.0.0.1', '::127.0.0.1', '::ffff:127.0.0.1' are treated equally
#	and '::/0' will allow any IPv4 or IPv6 address.
#	'0.0.0.0/0' can be used to allow any IPv4 address.
#	Example: AllowedIP=127.0.0.1,192.168.1.0/24,::1,2001:db8::/32,zabbix.example.com
#
# Mandatory: yes
# Default:
# AllowedIP=

AllowedIP=${ZBX_ALLOWEDIP}

### Option: ListenPort
#	Service will listen on this port for connections from the server.
#
# Mandatory: no
# Range: 1024-32767
# Default:
# ListenPort=10053

ListenPort=${ZBX_LISTENPORT}

### Option: Timeout
#	Spend no more than Timeout seconds on formatting dashboard as PDF
#
# Mandatory: no
# Range: 1-30
# Default:
# Timeout=10

Timeout=${ZBX_TIMEOUT}

### Option: TLSAccept
#	What incoming connections to accept.
#	Specifies what type of connection to use:
#		unencrypted - accept connections without encryption
#		cert        - accept connections secured with TLS and a certificate
#
# Mandatory: no
# Default:
# TLSAccept=unencrypted

TLSAccept=${ZBX_TLSACCEPT}

### Option: TLSCAFile
#	Full pathname of a file containing the top-level CA(s) certificates for
#	peer certificate verification.
#
# Mandatory: no
# Default:
# TLSCAFile=

TLSCAFile=${ZBX_TLSCAFILE}

### Option: TLSCertFile
#	Full pathname of a file containing the service certificate or certificate chain.
#
# Mandatory: no
# Default:
# TLSCertFile=

TLSCertFile=${ZBX_TLSCERTFILE}

### Option: TLSKeyFile
#	Full pathname of a file containing the service private key.
#
# Mandatory: no
# Default:
# TLSKeyFile=

TLSKeyFile=${ZBX_TLSKEYFILE}

### Option: IgnoreURLCertErrors
#	Ignore TLS certificate errors when accessing Frontend URL
#		0 - do not ignore
#		1 - ignore
#
# Mandatory: no
# Default:
# IgnoreURLCertErrors=0

IgnoreURLCertErrors=${ZBX_IGNOREURLCERTERRORS}