1
0
shorewall_code/Shorewall/hosts

59 lines
1.8 KiB
Plaintext
Raw Normal View History

#
# Shorewall 1.4 - /etc/shorewall/hosts
#
# THERE ARE TWO CASES WHERE YOU NEED THIS FILE:
#
# 1) YOU HAVE MULTIPLE NETWORKS IN THE SAME ZONE CONNECTED TO
# A SINGLE INTERFACE AND YOU WANT THE SHOREWALL BOX TO ROUTE
# BETWEEN THESE NETWORKS.
#
# 2) YOU HAVE MORE THAN ONE ZONE CONNECTED THROUGH A SINGLE
# INTERFACE.
#
# IF YOU DON'T HAVE EITHER OF THESE SITUATIONS THEN DON'T TOUCH
# THIS FILE.
#
# This file is used to define zones in terms of subnets and/or
# individual IP addresses. Most simple setups don't need to
# (should not) place anything in this file.
#
# ZONE - The name of a zone defined in /etc/shorewall/zones
#
# HOST(S) - The name of an interface followed by a colon (":") and
# either:
#
# a) The IP address of a host
# b) A subnetwork in the form
# <subnet-address>/<mask width>
#
# The interface must be defined in the
# /etc/shorewall/interfaces file.
#
# Examples:
#
# eth1:192.168.1.3
# eth2:192.168.2.0/24
#
# OPTIONS - A comma-separated list of options. Currently-defined
# options are:
#
# maclist - Connection requests from these hosts
# are compared against the contents of
# /etc/shorewall/maclist. If this option
# is specified, the interface must be
# an ethernet NIC and must be up before
# Shorewall is started.
#
# routeback - Shorewall show set up the infrastructure
# to pass packets from this/these
# address(es) back to themselves. This is
# necessary of hosts in this group use the
# services of a transparent proxy that is
# a member of the group or if DNAT is used
# to send requests originating from this
# group to a server in the group.
#
#
#ZONE HOST(S) OPTIONS
#LAST LINE -- ADD YOUR ENTRIES BEFORE THIS LINE -- DO NOT REMOVE