shorewall_code/Samples/two-interfaces/interfaces

243 lines
8.6 KiB
Plaintext
Raw Normal View History

#
# Shorewall version 2.6 - Interfaces File
#
# /etc/shorewall/interfaces
#
# You must add an entry in this file for each network interface on your
# firewall system.
#
# Columns are:
#
# ZONE Zone for this interface. Must match the short name
# of a zone defined in /etc/shorewall/zones.
#
# If the interface serves multiple zones that will be
# defined in the /etc/shorewall/hosts file, you should
# place "-" in this column.
#
# INTERFACE Name of interface. Each interface may be listed only
# once in this file. You may NOT specify the name of
# an alias (e.g., eth0:0) here; see
# http://www.shorewall.net/FAQ.htm#faq18
#
# You may specify wildcards here. For example, if you
# want to make an entry that applies to all PPP
# interfaces, use 'ppp+'.
#
# There is no need to define the loopback interface (lo)
# in this file.
#
# BROADCAST The broadcast address for the subnetwork to which the
# interface belongs. For P-T-P interfaces, this
# column is left blank.If the interface has multiple
# addresses on multiple subnets then list the broadcast
# addresses as a comma-separated list.
#
# If you use the special value "detect", the firewall
# will detect the broadcast address for you. If you
# select this option, the interface must be up before
# the firewall is started, you must have iproute
# installed.
#
# If you don't want to give a value for this column but
# you want to enter a value in the OPTIONS column, enter
# "-" in this column.
#
# OPTIONS A comma-separated list of options including the
# following:
#
# dhcp - Specify this option when any of
# the following are true:
# 1. the interface gets its IP address
# via DHCP
# 2. the interface is used by
# a DHCP server running on the firewall
# 3. you have a static IP but are on a LAN
# segment with lots of Laptop DHCP
# clients.
# 4. the interface is a bridge with
# a DHCP server on one port and DHCP
# clients on another port.
#
# norfc1918 - This interface should not receive
# any packets whose source is in one
# of the ranges reserved by RFC 1918
# (i.e., private or "non-routable"
# addresses. If packet mangling or
# connection-tracking match is enabled in
# your kernel, packets whose destination
# addresses are reserved by RFC 1918 are
# also rejected.
#
# routefilter - turn on kernel route filtering for this
# interface (anti-spoofing measure). This
# option can also be enabled globally in
# the /etc/shorewall/shorewall.conf file.
#
# logmartians - turn on kernel martian logging (logging
# of packets with impossible source
# addresses. It is suggested that if you
# set routefilter on an interface that
# you also set logmartians. This option
# may also be enabled globally in the
# /etc/shorewall/shorewall.conf file.
#
# blacklist - Check packets arriving on this interface
# against the /etc/shorewall/blacklist
# file.
#
# maclist - Connection requests from this interface
# are compared against the contents of
# /etc/shorewall/maclist. If this option
# is specified, the interface must be
# an ethernet NIC and must be up before
# Shorewall is started.
#
# tcpflags - Packets arriving on this interface are
# checked for certain illegal combinations
# of TCP flags. Packets found to have
# such a combination of flags are handled
# according to the setting of
# TCP_FLAGS_DISPOSITION after having been
# logged according to the setting of
# TCP_FLAGS_LOG_LEVEL.
#
# proxyarp -
# Sets
# /proc/sys/net/ipv4/conf/<interface>/proxy_arp.
# Do NOT use this option if you are
# employing Proxy ARP through entries in
# /etc/shorewall/proxyarp. This option is
# intended soley for use with Proxy ARP
# sub-networking as described at:
# http://www.tldp.org/HOWTO/mini/Proxy-ARP-Subnet
#
# newnotsyn - TCP packets that don't have the SYN
# flag set and which are not part of an
# established connection will be accepted
# from this interface, even if
# NEWNOTSYN=No has been specified in
# /etc/shorewall/shorewall.conf. In other
# words, packets coming in on this
# interface are processed as if
# NEWNOTSYN=Yes had been specified in
# /etc/shorewall/shorewall.conf.
#
# This option has no effect if
# NEWNOTSYN=Yes.
#
# It is the opinion of the author that
# NEWNOTSYN=No creates more problems than
# it solves and I recommend against using
# that setting in shorewall.conf (hence
# making the use of the 'newnotsyn'
# interface option unnecessary).
#
# routeback - If specified, indicates that Shorewall
# should include rules that allow
# filtering traffic arriving on this
# interface back out that same interface.
#
# arp_filter - If specified, this interface will only
# respond to ARP who-has requests for IP
# addresses configured on the interface.
# If not specified, the interface can
# respond to ARP who-has requests for
# IP addresses on any of the firewall's
# interface. The interface must be up
# when Shorewall is started.
#
# arp_ignore[=<number>]
# - If specified, this interface will
# respond to arp requests based on the
# value of <number>.
#
# 1 - reply only if the target IP address
# is local address configured on the
# incoming interface
#
# 2 - reply only if the target IP address
# is local address configured on the
# incoming interface and both with the
# sender's IP address are part from same
# subnet on this interface
#
# 3 - do not reply for local addresses
# configured with scope host, only
# resolutions for global and link
# addresses are replied
#
# 4-7 - reserved
#
# 8 - do not reply for all local
# addresses
#
# If no <number> is given then the value
# 1 is assumed
#
# WARNING -- DO NOT SPECIFY arp_ignore
# FOR ANY INTERFACE INVOLVED IN PROXY ARP.
#
# nosmurfs - Filter packets for smurfs
# (packets with a broadcast
# address as the source).
#
# Smurfs will be optionally logged based
# on the setting of SMURF_LOG_LEVEL in
# shorewall.conf. After logging, the
# packets are dropped.
#
# detectnets - Automatically taylors the zone named
# in the ZONE column to include only those
# hosts routed through the interface.
#
# upnp - Incoming requests from this interface
# may be remapped via UPNP (upnpd).
#
# WARNING: DO NOT SET THE detectnets OPTION ON YOUR
# INTERNET INTERFACE.
#
# The order in which you list the options is not
# significant but the list should have no embedded white
# space.
#
# GATEWAY This column is only meaningful if the 'default' OPTION
# is given -- it is ignored otherwise. You may specify
# the default gateway IP address for this interface here
# and Shorewall will use that IP address rather than any
# that it finds in the main routing table.
#
# Example 1: Suppose you have eth0 connected to a DSL modem and
# eth1 connected to your local network and that your
# local subnet is 192.168.1.0/24. The interface gets
# it's IP address via DHCP from subnet
# 206.191.149.192/27. You have a DMZ with subnet
# 192.168.2.0/24 using eth2.
#
# Your entries for this setup would look like:
#
# net eth0 206.191.149.223 dhcp
# local eth1 192.168.1.255
# dmz eth2 192.168.2.255
#
# Example 2: The same configuration without specifying broadcast
# addresses is:
#
# net eth0 detect dhcp
# loc eth1 detect
# dmz eth2 detect
#
# Example 3: You have a simple dial-in system with no ethernet
# connections.
#
# net ppp0 -
#
# For additional information, see
# http://shorewall.net/Documentation.htm#Interfaces
#
###############################################################################
#ZONE INTERFACE BROADCAST OPTIONS GATEWAY
net eth0 detect dhcp,tcpflags,norfc1918,routefilter,nosmurfs,logmartians
loc eth1 detect tcpflags,detectnets
#LAST LINE -- ADD YOUR ENTRIES BEFORE THIS ONE -- DO NOT REMOVE