#	
# 	Shorewall 1.4  -- Sample Interface File For One Interface
#
# 	/etc/shorewall/interfaces
#
#	You must add an entry in this file for each network interface on your
#	firewall system.
#
# Columns are:
#
#	ZONE		Zone for this interface. Must match the short name
#			of a zone defined in /etc/shorewall/zones.
#
#			If the interface serves multiple zones that will be
#			defined in the /etc/shorewall/hosts file, you should
#			place "-" in this column.
#	
#	INTERFACE	Name of interface. Each interface may be listed only
#			once in this file. You may NOT specify the name of
#			an alias (e.g., eth0:0) here; see
#			http://www.shorewall.net/FAQ.htm#faq18
#
#			DO NOT DEFINE THE LOOPBACK INTERFACE (lo) IN THIS FILE.
#
#	BROADCAST	The broadcast address for the subnetwork to which the
#			interface belongs. For P-T-P interfaces, this
#			column is left blank.If the interface has multiple
#			addresses on multiple subnets then list the broadcast
#			addresses as a comma-separated list.
#					    
#			If you use the special value "detect", the firewall
#			will detect the broadcast address for you. If you
#			select this option, the interface must be up before
#			the firewall is started, you must have iproute
#			installed and the interface must only be associated
#			with a single subnet.
#
#			If you don't want to give a value for this column but
#			you want to enter a value in the OPTIONS column, enter
#			"-" in this column.
#
#	OPTIONS		A comma-separated list of options including the
#			following:
#
#			dhcp
#					Interface is managed by DHCP or used by
#					a DHCP server running on the firewall or
#					you have a static IP but are on a LAN
#					segment with lots of Laptop DHCP clients.
#			norfc1918
#					This interface should not receive
#					any packets whose source is in one
#					of the ranges reserved by RFC 1918
#					(i.e., private or "non-routable"
#					addresses. If packet mangling is
#					enabled in shorewall.conf, packets
#					whose destination addresses are
#					reserved by RFC 1918 are also rejected.
#			routefilter
#					Turn on kernel route filtering for this
#					interface (anti-spoofing measure). This
#					option can also be enabled globally in
#					the /etc/shorewall/shorewall.conf file.
#			dropunclean
#					Logs and drops mangled/invalid packets
#			logunclean
#					Logs mangled/invalid packets but does
#					not drop them.
#			blacklist
#					Check packets arriving on this interface
#					against the /etc/shorewall/blacklist
#					file.
#			maclist
#					Connection requests from this interface
#					are compared against the contents of
#					/etc/shorewall/maclist. If this option
#					is specified, the interface must be
#					an ethernet NIC and must be up before
#					Shorewall is started.
#			tcpflags
#					Packets arriving on this interface are
#					checked for certain illegal combinations
#					of TCP flags. Packets found to have
#					such a combination of flags are handled
#					according to the setting of
#					TCP_FLAGS_DISPOSITION after having been
#					logged according to the setting of
#					TCP_FLAGS_LOG_LEVEL.
#			proxyarp
#					Sets /proc/sys/net/ipv4/conf/<interface>/proxy_arp.
#					Do NOT use this option if you are
#					employing Proxy ARP through entries in
#					/etc/shorewall/proxyarp. This option is
#					intended soley for use with Proxy ARP
#					sub-networking as described at:
#					http://www.tldp.org/HOWTO/mini/Proxy-ARP-Subnet
#
#			The order in which you list the options is not
#			significant but the list should have no embedded white
#			space.
#
#	Example 1:
#			Suppose you have eth0 connected to a DSL modem
#			that gets it's IP address via DHCP from subnet
#			206.191.149.192/27.
#
#			Your entries for this setup would look like:
#
#			#ZONE	INTERFACE	BROADCAST	OPTIONS
#			net	eth0		206.191.149.223	dhcp
#
#	Example 2:
#			The same configuration without specifying broadcast
#			addresses is:
#
#			#ZONE	INTERFACE	BROADCAST	OPTIONS
#			net	eth0		detect		dhcp
#
#	Example 3:
#			You have a simple dial-in system with no ethernet
#			connections.
#			#ZONE	INTERFACE	BROADCAST	OPTIONS
#			net	ppp0		-
##############################################################################
#ZONE	INTERFACE	BROADCAST	OPTIONS
net	eth0		detect		norfc1918,routefilter,dhcp
#LAST LINE -- ADD YOUR ENTRIES BEFORE THIS ONE -- DO NOT REMOVE